4 Replies Latest reply on Sep 14, 2017 8:34 AM by srdr

    How to force bind the interrupts to cyusb3 driver for the first time?

    ashwin.techie9396_2689836

      I am trying to use the UVC application. We would like to use our vendor ID and product ID and force bind it to the driver. I have edited the cyusb3.inf and added our vendor ID and product ID. But still I am not able to force bind the interrupt to the driver. I have followed all the steps from Cypress Cyusb3.sys Programmer's reference.

       

      Also FX3 is detected twice, one in Imaging devices and in Other devices section
      Driver is detected properly in imaging devices section but I am unable to install it in the other devices section.
      USB Control Center by Cypress is also not detecting my board.
      How can I solve this issue?