2 Replies Latest reply on Sep 8, 2017 12:08 AM by RyanZ_36

Programming PSoC4 with Miniprog3

xuwenwei_1723161 Sep 1, 2017 12:40 AM

Dear ,

I use PSoC Programmer 3.26.0 to program PSoC4 , it is successful.

but when I PPCLI.exe to Programming,when I use PSoC4_EraseAll, it will show error as follow:

>PSoC4_EraseAll

SWD respond packet contains Failed status!

PSoC4_EraseAll returned 80004005

80004005 OK

anybody can tell me why?

the detail as follow Picture.

1. Re: Programming PSoC4 with Miniprog3

AnkitaS_51 Sep 3, 2017 11:17 PM (in response to xuwenwei_1723161)

I suggest you to go through these Forum threads for identification of cause for the issue-

programming with miniprog3
Programming PSoC5 with miniprog3 using 5pin connector
Like Show 0 Likes(0)

Actions
2. Re: Programming PSoC4 with Miniprog3

RyanZ_36 Sep 8, 2017 12:08 AM (in response to xuwenwei_1723161)

The error log said there were some bad SWD response. Could you double-check the SWD connection?
Like Show 0 Likes(0)

Actions