Can you please post your complete project or a shortened version that shows the error so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Here I have archieved my project and attached it. While transmitting Numbers the output is file for getting and receiving and also need help in adding the Interrupt in the SCB component
I am assuming you are using a CY8CKIT-042 Pioneer Kit. Is that right?
Did you make the required connections as shown on page 71 in the kit guide?
You should use the #defined constants for the initialization. I started to put them into your struct but found a wrong value for oversampling. should be 16, but is 13. can you continue replacing your struct values?
I am not Using CY8CKIT-042. Its a development Board designed outside using Cypress IC. However while using the Sampling Rate as 13 if I am Passing a string I am getting the desired Output and works fine on passing whatever the string is. However the problem is in the receiver part.
When I go through the design of Cy8CKIT-030 on the receiver end there is 100 ohm connected to it (i.e. from Rx Pin In development kit to Max232.). Can I know the purpose of using 100Ohm on receiver part alone?
Finally got the Output. The issue is while using the baud rates of 9600 & 14400, but when I use baud rates above 14400 I can transmit and receive properly.
If any one can help me in the Unconfigured SCB using Rx Interrupt.
I need to know how to set the interrupt as SCB_INTR_RX_NOT_EMPTY and when received any data need to transmit
That doesn't fits the case. In that Example the UART(SCB) had been used, but I need help in using Interrupt in unconfigured Mode.
Thanks for the reply.