1 Reply Latest reply on Sep 3, 2017 11:11 PM by rghe

    Achieve super speed in FX3?

    piyushashtikar

      I have a ZTEX USB-FPGA module 2.14 with onboard FX3.

      https://www.ztex.de/firmware-kit/example.e.html

      I am following above link of sample example to test.

       

      It works perfectly fine, but I get a message

      Info: USB setup finished: high speed

      whereas in the example as shown, they get

      Info: USB setup finished: super speed

       

      My question is can anyone hint me where to look at, as I am following same steps but not able to

      connect at super speed?