2 Replies Latest reply on Dec 21, 2015 4:18 AM by elisangela.1483516

    Doubt - Hardware Project - EZ-BLE PRoC Module

    elisangela.1483516

      Hi, I am developing a portable device and I am using EZ-BLE PRoC Module in my project. In AN96841 document Cypress recommend to place the BLE module in the corner of my board. There is a "design recommending" that suggest keep about 4 mm around the board, please look at the picture 1.

         

      However I have very little space available in my project. 

         
            
      1. Can I put others devices in the same layer that EZ-BLE PRoC?
      2.     
      3. Can I put battery and vibration motor in the same layer that EZ-BLE PRoC? 
      4.    
         

      (please look at the picture 2)

         

          3.  Can I reduce the distance between BLE module and Battery for 2 mm?

         

      (Please, look at the picture 3)

         

          4.  Can I reduce the distance between BLE module and vibration motor for 2 mm?

         

      (Please, look at the picture 3)