1 2 Previous Next 18 Replies Latest reply on Jun 5, 2017 6:31 AM by thinhdoluongcantho_2433901

    UART communication issue

    rajakumari.satyasri_2104806

      Hi,

         

      I have tested the UART comm with P7.0 P7.1 on cypress CY8CKIT-043, its working good able to get the debug messages.

         

      But I need to configure other UART also.

         

      I have configured the set of pins P6.0, P6.1 and P5.0,P5.1.

         

      I can able to detect the UART port  with serial to USB connector with UART Rx,Tx, gnd lines connected,

         

      but I am getting garbage data. I have configured the baud rate to 115200, but its not giving correct data.

         

      Is there anything need to configure for uart?

        1 2 Previous Next