Reclaim Port1 pins on KIT-059

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
odissey1
Level 9
Level 9
First comment on KBA 1000 replies posted 750 replies posted

Hi,

   

I want to make use of entire Port1 of CY8KIT-059 (PSoc5 stick). Unfortunately, Pins 1.0, 1.1 and 1.3 are taken by JTAG and not assignable (screenshot attached). Is there any way to reclaim those pins? Are they become available if using Miniprog3?

0 Likes
1 Solution
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

Just setting the debug mode to GPIO (in System view) will free all pins to normal use. Setting those to SWD will keep the kitprog debugging active but will need two pins.

   

 

   

Bob

View solution in original post

0 Likes
3 Replies
odissey1
Level 9
Level 9
First comment on KBA 1000 replies posted 750 replies posted

screenshot

   

   

   

0 Likes
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

Just setting the debug mode to GPIO (in System view) will free all pins to normal use. Setting those to SWD will keep the kitprog debugging active but will need two pins.

   

 

   

Bob

0 Likes
odissey1
Level 9
Level 9
First comment on KBA 1000 replies posted 750 replies posted

Thank you Bob. That was easy.

0 Likes