5 Replies Latest reply on Nov 24, 2011 12:39 AM by content.librarian

    CY3210 MiniProg1 Kit

    shaik.baji
              Hi Support team,   
         
      My name is "Shaik", I am new to "Embedded Systems". I have confused with few components of "CY3210 MiniProg1 MiniEval1" so can you please clarify my doubts?   
         
         
      I have highlighted few components of "CY3210 MiniProg1 MiniEval1" with "red colored boxes" in the attached JPG file so can you describe me what actually they are? and what the purpose of those?   
         
      Thanks in advance.   
         
         
      Regards,   
      Shaik   
        • 1. Re: CY3210 MiniProg1 Kit
          content.librarian
                  Hi,   
             
          I don't find any attachment here.   
             
          -Brijesh   
          • 2. Re: CY3210 MiniProg1 Kit
            shaik.baji
                    Hi Brijesh,   
               
            Thank you very much for your reply. Now i have attached the JPG file so please refer it once and describes me what they are?   
               
               
            Regards,   
            Shaik   
            • 3. Re: CY3210 MiniProg1 Kit
              content.librarian
                      Hi Shaik,   
                 
                 
              Please find the attached schematic of this board.   
                 
              Connector J1-------port 2 is brought out   
              Jumper JP1--------Vcc selection for 8 pin or 20 pin device   
              Connector J2------ISSP connector for programming purpose   
              R6 is trim pot   
                 
              Cheers,   
              Brijesh   
              • 4. Re: CY3210 MiniProg1 Kit
                shaik.baji
                        Hi ,   
                   
                Thank you Brijiesh. Now i have cleared about what they are but I don't know what's the functionalities of those.   
                   
                1) You have specified that   
                   
                Connector J1-------port 2 is brought out   
                Jumper JP1--------Vcc selection for 8 pin or 20 pin device   
                Connector J2------ISSP connector for programming purpose   
                R6 is trim pot   
                   
                but what It's actual purpose or functionality of those "Connector J1" , "Jumper JP1" , "R6"?   
                   
                2) What do you mean by "POT" ? Is there any abbreviation for "POT"? and what is the core functionality of "POT"?   
                   
                3) Can i directly connect to "Connector J2 (ISSP)" without using "PSoC MiniProg"? I mean can i connect the board directly from my PC? If so how can i do that?   
                   
                   
                Regards,   
                Shaik Baji   
                • 5. Re: CY3210 MiniProg1 Kit
                  content.librarian

                  Hi Shaik,

                  Trim Pot word I used for variable resistor.

                  Please refer schematic.

                  To understand other basic stuff I recommend you to go through PSoC basic trainings.

                  You will find couple of basic on demand trainings on following link:

                  http://www.cypress.com/?id=1327&source=header

                  Cheers,
                  Brijesh