Anonymous
Not applicable
May 17, 2010
09:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 17, 2010
09:50 PM
Dear Forum,
I'm using a CY3280-BK1 capsense development kit, and I'm trying to program a CY7C24794.
I'm using a PSoC MiniProg to plug into the board from the PC and I was using P1(0) and P1(1) for clock and data and that wasn't working, so after reading some of the forum topics, I tried (5) and (7) instead, but that's not doing it.
I get "Unable to Locate Device."
Labels
- Labels:
-
PSoC 5LP
1 Reply
Anonymous
Not applicable
May 18, 2010
12:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 18, 2010
12:54 PM
what is your programming mode: reset or pwercycle? also, what is the Device Family and Device shown in Programmer?