Since the mfg_test program on BCM4390 does not work for us,
and the setup is so trivial.
I'd like to know if it SHOULD WORK or NOT in SDK3.1.0?
I got the same errors here.
I couldn't even get the snip.scan working. I was able to get wwd.scan working 5-10 scans and then it stop scanning. Any luck with either of the scan apps?
The snip.scan looks fine here without any modification.
we also have the same problem in SDK 3.1
we have test two type of 4390 board.
while scan, it become hangup.
so we are waiting for new sdk and new EVB.
if you have no problem, please advise your module part# and EVB #
Any idea where it's hanging up? Mine hangs on the following:
result = wiced_rtos_get_semaphore( &scan_semaphore, SCAN_LONGEST_WAIT_TIME );
The first time it is called from wiced_wifi_scan_networks(scan_result_handler, NULL );
Did you find answer for this issue ?
Not so much time for this one, so I came back to this 4390 to find this problem.
- snip.scan hanup occured in ThreadX and FreeRTOS
This is demo code project with SDK and it has scan command.
This scan command also goes to hangup.
- So I think that this is not application level issues.
- This problem comes scan count like
Waiting for scan results [ #of scan count= 3 ] // hangup after 3 times scan
Waiting for scan results [ #of scan count= 8 ] // hangup after 8 times scan
Waiting for scan results [ #of scan count= 52 ] // hangup after 52 times scan
Waiting for scan results [ #of scan count= 72 ] // hangup after 72 times scan
- This seems to be effected by air environment
- Is it also have same problem that this 4390 module can not be connected AP which supports HT20/HT40 ?
If you have valid information, please advise me.