- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I wish to attach an external A/D to the PSOC5LP. The external A/D is running at 20MSPS and has an 8 bit parallel output. Would a EMIF and a DMA channel be the best bet?
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
DMA would be sufficient, you don't nened EMIF (unless the ADC you are using has a real memory-style interface which I doubt).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
DMA would be sufficient, you don't nened EMIF (unless the ADC you are using has a real memory-style interface which I doubt).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hli:
Thanks for the prompt response. My problem is simple. I assume I connect the A/D to a 8 pin port. I place a DMA component on the schematic. I fire up the DMA wizard. The destination is SRAM, but what is the source?
Thanks,
Ed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Add a status register connected to your port. The the DMA source is StatusReg_Status_PTR.