1 Reply Latest reply on Feb 2, 2014 2:30 AM by rama.sai.krishna.vakkantula

    cy7C68013 C0.C2 mode

    @zju.edu.cn

       i have write a  firmware, and use the kneil 4 to compile it, when output, i use the command as below:

         

       

         

      Hex2bix.exe -i  -o bulktogpif.iic bulktogpif.hex -f 0xC2 -v 0x0451 -p 0x32AF

         
          the i use the control center download it to EEPROM, and the software show it programmed successfully, and i also load    
         
          the sprit file and display the sprit,   
         
              
         
          But, it seems that the usb is started as the C0 mode,    
         
              
         
          can you help me, how can i know whether EEPROM is programming successfully and the 68013 is working by load the firmware which is written by myself?