1 Reply Latest reply on Apr 9, 2010 3:11 PM by anand.srinivasan.asokan

    where do i configure the endpoints in the codes?

    eric.sun
              hi, guys and gals.   
      I have just started projects with FX2. I have some puzzles about the endpoints configurations. My puzzle follows below:   
      For the high speed mode of FX2, the default descriptors provide 4 different interface configurations, and under each of the configurations, the features of the endpoints are different. So under such cases, where do i put the codes for the endpoints configuration in order to support multiple interfaces?   
         
      thanks in advance.   
         
      best regards,   
         
      eric