2 Replies Latest reply on Jun 15, 2010 3:11 AM by tong.tong

    killed after ad a ezi2c in chip mode

    joan.va.casanova
              i'm trying to do some test with designer5 in chip mode.   
      led blinking , pwm 8 controled led and at the end, ezi2c in slave mode.   
      i have assigned pins 7 ^ 5 in the properties of the control as sda ^ scl.   
      The intention was to controll some variables using   
      the Bridge control panel.   
         
      in this last test, after program the FTMF the blue led on the FTPC stop flashing , and is   
      not possible to program again the FTMF. if i remove the module, the blue led blink again.. if i conect the FTMF the FTPC appears as disconected.   
         
      There is some way to recover from this point ?   
         
      thankyou