- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am currently trying to use PLT and ADCINCVR modules at the same time. There are still some ports left after PLT been assigned, however input of ADCINCVR couldn't be assigned from the other available ports. Do you know how to assign the spare port into the ADCINCVR?
The picture attached below is what i am facing now. Input that i need to asssign is Port_0_7 but the ADC itself proposed different input as shown in the diagram while Port_0_7 is not in used.
Your help and reply is much much appreciated.
Thanks,
Alex
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have the same problem as well for my powerline communication project. I cant select required input port from ADCINCR if i place PLT user module at the same time. Please verify because i purchased a pair of cy3276 development kits for my project. I believe that this PSoC Designer can do that.