- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi.. I have a cy3209-ExpressEVK kit. my problem is, How i can connect Zigbee transceiver(UART) to SPI radio socket.
So. Please Help me to solve this problem.
Thank you
Keyur Patel
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The pins that connect to the radio socket need not be connected only to SPI. In your PSoC designer project, you can have an UART user module and connect the TX and RX pins to the PSoC port pins that connect to the Radio socket. In the CY3209 schematic, check which port pins connect to the radio module connector and use these pins for the TX and RX of the UART.
Best Regards,
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much for your reply.
But i have another problem. I have a kit cy3209 that i have described earlier and with that kit one software cd is also their but in that cd i didn't get PSoC Designer. only Psoc express i have. So what should i have to do?
Can i work with any version of Psoc designer?
Thank you
Keyur Patel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes. You can use the latest version of PSoC Designer from cypress website from the below link.
http://www.cypress.com/?id=2522
Best Regards,
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The errors mean that there is typo in the ADC APIs that you are using. What is the name of the ADC in your project? Make sure that the ADC APIs are preceded by the exact name given to the user module in the device editor. If you are not able to find the problem, zip the complete project folder and post it here so that I can have a look at it.
Best Regards,
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi.
Thank you very much for your kind reply.
I am going to write code once again for another controller-cy8c29666.
After that i'll send you complete zip file with all the details.
thank you.