4 Replies Latest reply on Jun 10, 2011 6:23 AM by knud.allan

    Unable to program PSoC, select debug target and nothing is listed

    steven.jackson

      I tried searching for a solution and did not find much. Hopefully the fix is trivial...

         

      I have a CY8CKIT-001 Development Board and I installed the PSoC 3 and all necessary software.

         

       

         

      I am trying to load Example 1 LED and am reading the documentation steps. I go to debug->select debug target and nothing is listed. I am trying to configure the MiniProg3 device...

         

       

         

      Under project->device selector all devices have a question mark. I run start auto select and nothing changes