2 Replies Latest reply on Jun 5, 2012 3:44 AM by yang.wang

    couldn't debug!

    yang.wang

      when i clicked the Debug(F5), the debug was interrupted.

         

      and the error as follows: 

         

      Error: dbg.M0015: Debugger exited unexpectedly during run.  Encountered error (Remote communication error: No error.)

        • 1. Re: couldn't debug!
          user_1377889

          There are several reasons:

             

          I had the very same error because my username in windows contained a non-ascii character (use no accents, nothing special, no spaces...)

             

          Some users had troubles with the USB-Cable

             

          Check (double-check) the power-setting of your Miniprog3, setting should be SWD 10pin interface.

             

           

             

          Bob 

          • 2. Re: couldn't debug!
            yang.wang

            thanks for your reply. i debug the example project in PSoC creator 2.0.the attach is the clock configuration.i don't know where the problem is.