Since you are using 100 pin CY8C5588 part, you can enable Optional XRES on P1 by selecting the same in the System tab of the .cydwr file.
It can be found at the following location:
.cydwr file > System > Programming / Debugging > Use Optional XRES
The snap-shot below shows the setting done.
Found it.. thanks.
I would enalble the optional reset but I can't find that option in the programming\debugging menu.
I use PSoC Creator 2 and I see only two options:
- Debug Select
- Enable Device Protection
I use a CY8C5588AXI-060.
The optional XRES input (p1) is no longer supported and has been disabled (it is no longer presented in the System design-wide editor).
This feature has been disabled for PSoC5 in PSoC Creator 2.0