2 Replies Latest reply on Feb 28, 2012 12:49 PM by user_6153427

    GPIO with external pullup

    user_6153427

      Can I run a GPIO pin as output, open drain, drive low and attach an external pullup to 5V while the system is running 3.3V? All VDDIO is 3.3V.

        • 1. Re: GPIO with external pullup
          udayan.umapathi

          Hello there ! This is an interesting question. When you have an external pullup connected to 5V with VDDIO being 3.3V it is not going to be a good thing. This is because, When the Pin is in Open Drain state, all the 5V drops across the internal MOSFET. Also the external 5V supply now will start fighting with the 3.3V via internal diode, this is bad for your chip.

             

          There are a couple of solutions for this. The easiset solution for this is, "USE AN SIO". This is the kind of problem SIO is mean to solve. On an SIO you can have an external pull up with 5V while he VDDIO is 3.3 V. If you already dont know what an SIO is please go through the Pin component datasheet and PSoC3 datasheet. They are divided among the 4 Quadrants of pins on PSoC3 with one pair per quadrant. All SIOs belong to Port P12.

          • 2. Re: GPIO with external pullup
            user_6153427

            Thanks, I thought this might be the case but just wanted to confirm.