- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a smartbridge board and would like to develop on it on the MAC> I have been workingon the BCM943362WCD4 on the mac using the SDK and was hoping to do the same with the smartbridge eval board. Is this possible ?
Thanks
Kartik
Solved! Go to Solution.
- Labels:
-
SDK 2.4.1
-
SDK 3.x
-
SPI
-
Wifi+Bluetooth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Would like to confirm about setting up the 3.0.1 SDK into the Eclipse Environment. I downloaded the 3.0.1 SDK with MFi support and after unarchiving, couldn't find an eclipse project to import. So I created a new eclipse project and tried to bring the SDK in. There are no predefined build targets but I can make new ones on my own and they seem to work. Is there anything else that I need to do to get the SDK to integrate with eclipse ?
Thanks
Kartik
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is listed as a platform in the 3.0 SDK. I have given you access.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi gangi... thanks for the access... i notice there is only an windows installer for the SDK and IDE. Is there a Mac installer available? If not how can I modify the the existing eclipse wiced environment to use the new SDK and the associated tools (like Open OCD et al ).
Thanks
Kartik
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Would like to confirm about setting up the 3.0.1 SDK into the Eclipse Environment. I downloaded the 3.0.1 SDK with MFi support and after unarchiving, couldn't find an eclipse project to import. So I created a new eclipse project and tried to bring the SDK in. There are no predefined build targets but I can make new ones on my own and they seem to work. Is there anything else that I need to do to get the SDK to integrate with eclipse ?
Thanks
Kartik
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That should be it.