Anonymous
Not applicable
Jun 17, 2012
06:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 17, 2012
06:17 AM
Can I change the configuration of the chip during the operation?
for example: CY821434 set (ADC10_1, I2Cm_1), at run-time algorithm to disconnect ADC10_1 and connect Cap Sensors CSD.
Labels
- Labels:
-
PSoC 1
3 Replies
Jun 17, 2012
03:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 17, 2012
03:08 PM
Yes, thru register writes. A training video -
http://www.cypress.com/?id=1162&tagID=2522
The register specifics are in Register TRM (Technical reference Manual).
Regards, Dana.
Jun 17, 2012
03:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 17, 2012
03:16 PM
A word of caution, this would not be trivial as there are a number of issues
relating to "tuning" a cap sense design, but this should help you -
http://www.cypress.com/?docID=32332
Regards, Dana.
Anonymous
Not applicable
Jun 18, 2012
12:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 18, 2012
12:16 PM
Thank you very much for the information