5 Replies Latest reply on Jul 5, 2012 1:16 PM by user_14586677

    Pins on PSoC Creator

    jeisson.andrs.quiroz.gmez

       How I can change state (0 to 1), a pin on PSoC Creator?

         

      I'm trying to make an application for an SPI master in a PSoC5 using the component provided by PSoC Creator. The device that I'm using as SPI slave, is a chip of reference ADS1298 from TI.

         

      To complete the implementation of SPI communication, between PSoC5 and ADS1298, I need to put 3 pins that correspond to outputs digitals in PSoC Creator. The pins are: "Power_Down", "Reset" and "Start", these pins are normally 0, but after some delays programmed for each of them must change state to 1. How do I do it?

         

      Hope you can help me, is urgent...

         

      Thank you very much