Jul 11, 2012
03:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 11, 2012
03:58 AM
Hello, everyone,
I am checking the Cyfxusbi2sdmamode example. But the data value in the control center is only 0, so I can not check if the transfer is successful or not by monitoring the SD pin (it is always 0). Could anyone point me out that how to change the transfer vaule (not always 00) in the control center?
Thank you very much,
Lehua Chen
1 Reply
Jul 11, 2012
04:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 11, 2012
04:12 AM
Forget the former question. I can easily change the sending value by typing in the value.
But I still only get constant 0. It seems the data is not transferred out successfully.
Best,
Lehua Chen