Anonymous
Not applicable
Jul 17, 2012
01:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 17, 2012
01:04 PM
Does INT# work in Slave FIFO 32-bit mode?
1 Reply
Anonymous
Not applicable
Jul 18, 2012
02:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 18, 2012
02:32 AM
You can find details on this in the page 32(Pin Description section) of the FX3 data sheet.
INT# line acts as a control line when you configure the GPIF to work in Slave. It is available as INT# when you configure GPIF as master.
Regards,
sai krishna.