2 Replies Latest reply on Aug 27, 2012 4:07 AM by userc_43940

    Error:CPU is not halted

       Hi everyone:


      When I setup the debug mode with JTAG GDB,through the J-Link command Tool the ARAM9 is recognized,but the J-Link show a error message :"Error:CPU is not halted".And I follow the chapter 12 of FX3 programmers manual(DOC.#001-64707)to setup the eclipse IDE Debugger,then the tool show a error message “An internal error occurred during: "Label Job".




      ”.as attached file.


      could you please give some advice to slove the problem.


      Thanks for your attention and help!