Anonymous
Not applicable
Jul 29, 2014
08:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2014
08:37 PM
I'm using the Wi-Fi board (BCM943362WCD4) WICED.
FRDM-KL25Z of Freescale is sending the acceleration sensor information to WICED board by UART.
I would like to send the sensor information to the server from WICED wirelessly and display the sensor information to the server, but I can't.
I have confirmed that WICED received data from the UART by the terminal software.
I have attempted the synthesis of UART.c and AP_content.c now.
Apps / wwd / appliance / AP_content.c
Apps / snip / uart / uart.c
Can I Change of where the program?
Also, What are the ways to achieve such a program?
takumi
Labels
- Labels:
-
SPI
1 Reply
Anonymous
Not applicable
Jul 29, 2014
08:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2014
08:41 PM
It looks same with below thread.
I would like to display on the server to receive data from the UART
What exactly would you like to know?