- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi to all,
do we have resistors and capacitors in creator 2.0 for psoc 3.if they are in creator from where can we access and their firmware.
thanks
PRP
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
R and C elements in PSOC 3 only exist as annotated/schematic components, are
not physical components.
That being said take a look at this - http://www.cypress.com/?app=forum&id=2233&rID=63395
Additionally depends on what you are using R & C for, trying to create a filter, there is a DFB
block on the chip to do filtering. You could always create a sampled data R or C via using a
mux as sampled data switch for R, with external C.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
R and C elements in PSOC 3 only exist as annotated/schematic components, are
not physical components.
That being said take a look at this - http://www.cypress.com/?app=forum&id=2233&rID=63395
Additionally depends on what you are using R & C for, trying to create a filter, there is a DFB
block on the chip to do filtering. You could always create a sampled data R or C via using a
mux as sampled data switch for R, with external C.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Small correction, this -
You could always create a sampled data R or C via using a
mux as sampled data switch for R, with external C.
Should be this -
You could always create a sampled data R using a mux as
sampled data switch for R, with external C. Its impractical
do do so with stray chip C due to values being so low.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
so we have to use these externally only