Anonymous
Not applicable
Nov 23, 2012
12:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 23, 2012
12:46 PM
I have a code which is running in the PSoC. But I need to debug the code without resetting the PSoC in the same condition. Whenever I connect Miniprog to PSoC the device gets reset. Why is such a behaviour seen???
I dont see the problem whenever I would have connected the Miniprog to the PSoC , run the code and do attach to running target rather I se this problem only when miniprog is not connected initially and device is running with code insisde and I try to attach MIniprog.
Labels
- Labels:
-
PSoC 5LP
1 Reply
Anonymous
Not applicable
Nov 24, 2012
01:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 24, 2012
01:53 AM
Yes. I also have seen this before. Probably create a tech support case and find out the details on why the device is getting reset when you connect a MiniProg3 to the running device.