9 Replies Latest reply on Sep 18, 2014 2:09 AM by MichaelF_56

    Questions sleep and deep sleep modes on BCM20737

    userc_6378

      Hello, guys.

       

      1. I use two BLE starter kit BCM20737TAG. One in host mode and other in slave mode. After connecting slave TAG to the host TAG and save to NV memory address of the connected host and sending data I turn into a deep sleep. After pressing on the user button SW1 (waking up due interrupt GPIO) restarts slave TAG. Please, tell me, how to determine what slave TAG start came from the deep sleep mode to exclude paring (send advertising) again? May be there is an example implementation?

       

      2. As I read on the community going to deep sleep mode is only possible in not connected state. How to perform explicitly disconnect slave from the host?

       

      3. What API functions are used to going to simple sleep and waking up from in?

       

      Thanks in advance for your replies