It is not easy but possible, you can find the circuit diagram of the board. Not sure if it comes with the board or in the CD.
These two thread may help
happy prototyping :-)
Yes, you can do that, but you need to supply all the needed signals. Out of the blue you need:
- on J1, the reset signal, the supply voltages and maybe the JTAG / SWD signals
- on J2-J4, you need to supply the supply voltages (Vdda and Vddio)
If you want to manipulate the module, you can connect the supply voltages together with some wires, then you would need only the connection on J1.
As for Vbat: you would need the internal boost converter for this, but this has been disabled on the PSoC5 devices due to some problems.
wouldn't it be easier to just design a basic CY8C5XXX breakout board?