0 Replies Latest reply on Jan 3, 2013 4:03 PM by user_14586677

    I2C Pin Settings

    user_14586677

      When placing the I2Cm module, it states it will setup the pins you select in

         

      the properties window, however when you look at the pin properties window

         

      you will see the pin set for STDCPU, HiZ. But if you look at the pin setting

         

      property selection there is a I2C SDA and I2C SCL choice, so it is confusing,

         

      accept the module setup of STDCPU or use the I2C SDA/SCL choices.

         

       

         

      Quick answer is stay with module setup of STDCPU, HiZ. The I2Cm module

         

      is making the correct choice. The I2C SDA/SCL settings are for the I2CHW

         

      module setup.

         

       

         

      This confusion will be cleared up in a future release.

         

       

         

      Regards, Dana.