Anonymous
Not applicable
Jan 05, 2013
05:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2013
05:01 AM
hi:
i am using the fx3 dvk board ,i open the UartAssist kit on the pc ,then load firmware in the fx3sdk examples(slfifosync),some information should be printed,but nothing happened ,so i modify the code :uartConfig.isDma = CyFalse;
the cycontrol recognized the device after load the firmware.why?
pcb:600-60015-01 rev03
identify code:16410-PAC027
1 Reply
Anonymous
Not applicable
Jan 05, 2013
10:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2013
10:35 PM
Hi,
The slavefifo examples in the SDK print a message on the UART only if there has been an error such as when an API doesnt return successfully.Please add a CyU3PDebugPrint() API call in the SlFifoAppThread_Entry() function after CyFxSlFifoApplnDebugInit() API call.This should print a message to UART.
Regards,
Subha