1 Reply Latest reply on Jan 5, 2013 10:35 PM by subha.komath

    the uart infterface dont work

    li.wusong

      hi:

         

      i am using the fx3 dvk board ,i open the UartAssist kit on the pc ,then load firmware in the fx3sdk examples(slfifosync),some information should be printed,but nothing happened ,so i modify the code :uartConfig.isDma = CyFalse;

         

      the cycontrol recognized the device after load the firmware.why?

         

      pcb:600-60015-01 rev03

         

      identify code:16410-PAC027

        • 1. Re: the uart infterface dont work
          subha.komath

           Hi,

             

          The slavefifo examples in the SDK print a message on the UART only if there has been an error such as when an API doesnt return successfully.Please add a CyU3PDebugPrint() API call in the SlFifoAppThread_Entry() function after CyFxSlFifoApplnDebugInit() API call.This should print a message to UART.

             

          Regards,

             

          Subha