- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
how do I watch a RX interrupt in UART register mode?
I configure the UART like below,but it doesn't work and the usb is not enumerate!
The "NULL" is insteaded by the UART callback function in the line of "apiRetStatus = CyU3PUartSetConfig (&uartConfig, NULL); ".
How can I make it work when the UART finish receive data produce a interrupt?Thank you very much!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
the usb3.0 chip is CYUSB3014!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We have example for register Rx Interrupt callback in register mode. Please create a tech support case at www.cpyress.com -> Support -> Technical Support for getting the same.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI,
I also need RX interrupt in UART register mode.
Could you please also let me know the information about that ?
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please create a tech support case. We can share the example.
Regards,
Gayathri