Anonymous
Not applicable
Mar 11, 2013
01:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 11, 2013
01:20 AM
Due to the mistake on the Sensor module layout, i will have to reconfigure data bus from GPIO[6], bus it seems the tool won't allow me to do so? it there any other solution?
Thanks
Owen
1 Reply
Anonymous
Not applicable
Mar 11, 2013
04:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 11, 2013
04:02 AM
Hi Owen,
I don't think there is a way to change the data lines.
If it is a control signal then we can just route it to other signal. But I don't think we can play with the data bus lines.
Thanks,
Sai Krishna.