Anonymous
Not applicable
Mar 11, 2013
04:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 11, 2013
04:53 PM
If I have an FX2LP in "ports" mode (IFCONFIG[1:0] = 00), can I programmatically control the CTL1 & CTL2 pins? Or are those pins only accessible in slave-FIFO and GPIF modes?
Thanks!
Chris
2 Replies
Anonymous
Not applicable
Mar 11, 2013
05:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 11, 2013
05:01 PM
Never mind, I found the answer; the register is GPIFIDLECTL, which I had ignored because I assumed it was only relevant to GPIF mode. But it works fine in ports mode too. Sorry for the noise.
Chris
Anonymous
Not applicable
Mar 11, 2013
09:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 11, 2013
09:35 PM
Thanks for updating the thread Chris.
-Sai Krishna.