- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I want to trace and debug my project. As wrote in 'Programmers Manual.pdf' I need to use Segger JLink probe. Should I choose one of this tools http://www.segger.com/development-tools.html? Which tool is more suitable?
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please download the required software from the following webpage:
http://www.segger.com/jlink-software.html
Thanks,
Sai Krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Say Krishna and Hikhil,
As I understand, I need to buy J-Link tool http://www.segger.com/jlink.html and download and install this software http://www.segger.com/jlink-software.html to debug FX3 firmware.
Is it right? Please, correct me if it is something wrong!
Thanks,
Olga
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You are right Olga.
Thanks,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Olga
There are other cheaper alternatives like Olimex ARM-USB-OCD-H.
Only that you will have to spend time to understand how to make it work with OpenOCD tool. It is not as straight forward as using Jlink Segger.
The guidelines for using Olimes Jtag device are mentioned in the Programmer's manual of FX3 SDK 1.2.3.
Thanks
Nikhil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have one more question.
Can I debug my firmware sources without using any additional device?
Thank you,
Olga
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You require JTAG probe for debugging.
-PRJI
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you!!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No problem.
As I mentioned there are cheaper alternatives to Jlink.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have bought a Segger Jlink and downloaded the software,when I trace and debug my project,the error occurred,how i do?