May 07, 2013
06:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 07, 2013
06:31 AM
I am using the cypress UVC example AN75779 , but when i use the cypress supplied gpif state machine i get backflow detected message and when i check the error is CYU3P_PIB_ERR_THR0_WR_OVERRUN.
I am sure that i have initiated the address and data counters properly. Is there any possible solution to this problem ??
Rags
1 Reply
Anonymous
Not applicable
Oct 08, 2015
11:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 08, 2015
11:00 AM
I have a MIPI based camera, that has a toshiba bridge mounted on the camera module, The bridge is configured properly, and the cmos camera is configured properly, But I get a black screen when I select the device in the viewer
what am i missing ? what else needs to be done in order for mippi / or camera module to work?