Did you try to power the CYRF69103 externally (not from the MiniProg3)?
Also, when I understand that error message right, yout MiniProg3 *A doesn't support power cycle programming (see http://www.cypress.com/?rID=2543 ), so you need to configure the Reset programming method.
Thank you for the reply, i have tried with external power supply also , again same error i'm getting?? Please reply!
CyRF series PSoC has to have special interface for programming.
As you see CyRF Dev-Kit, It needs special dongle for it.
But no worry, that is a simple circuit.
SDA and SCL must pull up by resisters, 5Kohm as the I2C interface.
You can easy to going made it.
With my experience, I could programming CyRF69213 by using Miniprog1 and this dongle.
However Miniprog3 can do as well, I guess.
CyRF Series has no RESET pin,
So basically, this psoc must needs Power-Cycle mode to programmer.
As this link [ http://www.cypress.com/?rID=38154 ]
It seems, when you upgrade your Miniprog3 to Rev-B, you can use power cycle mode.
If you have Miniprog1, you can do that right now.
Thank you for your reply, but if you check the MiniProg3 schematic those pull-up resisters are already there. So we can program CyRF directly without the dongle circuit.
I'm having MiniProg3 Rev *A, and it is possible for me to use Power cycle mode!!