This content has been marked as final. Show 5 replies
Did you check (scope) VDD, VDDA, VDDIO1 and XRES_N?
Of course, every value and wave form is no problem.
is there any pull-up/pull down ersistor in the xres pin?1 of 1 people found this helpful
Yes, XRES pin is pull up by Pins configuration,
And I pulled up by external resister, 51Kohm to ensure it.
Project was attached in this post.
[ http://www.cypress.com/?app=forum&id=2232&rID=85008 ]
Anyway, I gave up Hardware RESET,
And for next handy way, software RESET that was implemented.
So far, that is woking well now.
As a matter of fact: the Kit-030 has got a pushbutton for hardware-reset and it works without any flaws. There is nothing else connected to the XRES-pin except the button. So ther MUST be SOMETHING with your board. I would not risk to send out a design that has some flaw, even it is worked around.