I'm trying to do the PsOC 101 Lesson 10 where PWM data is sent to the LED from the bridge control panel via I2C . I'm doing exactly what is being done in the video, though when I type in the command "W 08 00 10" or any similar command, the echo in the control panel returns nacks for all of the values inputted. The scl and sda are assigned to pins 5 and 5, respectively. I'm fairly certain those are correct, because when I hit send, the green light on the board blinks. Attached is my project file.
Try switching the I2C_Start(); and I2C_EzI2CSetBuffer1(1, 1, i2cbuf); commands, to prevent possible corruption of the I2C code due to a character being immediately received when setting the internal software buffer to receive to.