0 Replies Latest reply on Nov 14, 2013 7:45 AM by DaKn_263916

    Designer Pin Editor Error


      I ran into a problem which I cannot reproduce.




      When setting a pin to Open Drain Low (ODL), I could not get the pin


      to take a StdCPU setting simultaneously. The only way I could


      get it to take ODL was to set pin to a global out buss (I was working on


      an output pin) rather than StdCPU..




      After exiting Designer, and re-entry, it now allows me to set ODL pin to StdCPU,


      and cannot reproduce error.








      Regards, Dana.