Post you project -
Use Internet Explorer or Firefox to upload project. Then Forum can try to help.
Also write both english and your native language in your post, we will
use Google Translate, as well as reading your English, to try to under-
stand your questions.
If you are using CY3217 (Miniprog1), you can either power the project
from the programmer menu after you program part, or remove
Miniprog1after programming and power from external power supply/battery.
If you power project from Miniprog1 the Miniprog1 can only supply
as much power as the USB port can provide. USB 1.0 150 mA, 2.0
I run samples in help software psocminiprogrammer this samples work fine but somtime one problem was acured: while program, module LED after several on and off stay on and program module was intrupt
Some thoughts -
1) Make sure your USB driver on PC is up to date. This normally
is done by updating chip set driver.
2) If your board draws a lot of power disconnect high power loads
when programming, or use an external 3'rd party board, like dip board
as an example.
3) Take a look at this ap note and its references -
I read AN2014 but I don't know what to do . in software Psoc Programmer What was done is that this does not happen
i have application that in first step write hex on module and module seprate from device psocminiprog and in two step contact usb port and write profile program on module . now i want know that how can use device psocminiprog in step two without Interrupting module from device thanks for help
Seems to me you are seeking a bootloader like operation.
You first program PSOC not using miniprog, then you want miniprog
to do additional programming. This is bootloader like operation, where
a kernal pre-loaded into PSOC directs further programming operation,
in this case from a miniprog.
Take a look at these to see if they may accomplish, with your modification, possibilities -
Otherwise I simply do not understand your question.