Anonymous
Not applicable
May 13, 2014
12:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 13, 2014
12:40 AM
Is it possible to be able to re-program the development kit boards with the factory hex file ? (Just in case, to troubleshoot the hardware to make sure it is still operating properly.) It tests the LCD, RS-232/USB communications, etc. I have the CY8CKIT-001 PSoC Development Kit. Thanks (esp. if you provide the files : ).
Labels
- Labels:
-
PSoC 5LP
3 Replies
May 13, 2014
03:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 13, 2014
03:22 AM
May 13, 2014
05:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 13, 2014
05:05 AM
I see you posted in the PSOC 3 forum, using the -001 board.
Answer is yes, and hex file is here - http://www.cypress.com/?rID=37464
Regards, Dana.
Anonymous
Not applicable
May 13, 2014
09:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 13, 2014
09:45 AM
I've been going through a lot of documentation, but missed that. Thanks, Dana !