Attachments are accessible only for community members.
May 16, 2014
11:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 16, 2014
11:03 AM
Hi everyone,
I use a L6234 three phase driver motor with my PSOC. To control my motor I need to get 3 PWM which are dephased 120° as you can see on the picture attached.
What is the best solution?
Thank you
Alexis
Labels
- Labels:
-
PSoC 5LP
5 Replies
May 16, 2014
12:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 16, 2014
12:54 PM
This might help -
http://m.eetindia.co.in/STATIC/PDF/200910/EEIOL_2009OCT29_SIG_AN_01.pdf?SOURCES=DOWNLOAD
Regards, Dana.
May 16, 2014
03:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 16, 2014
03:02 PM
thanks for you answer, but actually I haven't hall sensor, I don't need the regulation loop with PI .
May 16, 2014
09:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 16, 2014
09:06 PM
The main reason I posted it was using LUT to get the 120 degree
phase outputs for motor drive.
Regards, Dana.
Attachments are accessible only for community members.
May 17, 2014
05:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 17, 2014
05:16 AM
May 17, 2014
05:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 17, 2014
05:21 AM