2 Replies Latest reply on Jul 7, 2014 1:23 PM by ShopithamR_26

    end point not transferring data

       Hi guys,


      I am using an adc and USBFS (not USBUART) in a project. The adc output is being displayed on the lcd and simultaneously also being loaded into the endpoint of usb. I have configured usbfs for bulk transfer with endpoint 1 set for IN mode.


      However on execution, the transfer is not taking place and the program gets stuck at this command:




      I have attached my project file under the folder name "proj3".


      I would be grateful for any suggestions quickly.