I have a CY3210 Kit on order, will be here in a few days. I have looked at some getting started videos in preperation. My question , do you have to use the graphic part in PSoC designer to set up GPIO ports and Pins for I/O? And also to set up things like PWM and ADC. I am comparing Cypress to Atmel AVR, in the Atmel I would modify port registers and control registers for things like this. example DDRB=Ox08 = PORT B all inputs, or TCCR1A is timer counter control register 1A and you modify the bits . Hope this makes sence , that is my question.