- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have just installed Designer 5.4 and tried to open a project given to me by someone else which has part CY8CTST242. The project will not open. When I open a new project and look for the part, it is not in the list. Are there files available which can be added to the 5.4 install to allow this part to be used?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Looking at PSOC programmer also not listed. Looking at datasheet
do not see a core mentioned, maybe a non PSOC type part core ?
Did project use this as a peripheral to a processor like another PSOC
1/3/4/5 ? In that case thats the part project should open under.
You can always post the project and Forum can take a look at.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You might want to contact your local FAE or sales office or manufacturers rep for
help.
Or file a CASE -
To create a technical case at Cypress -
“Support”
“Technical Support”
“Create a Case”
You have to be registered on Cypress web site first.
Regards, Dana.