3 Replies Latest reply on Dec 5, 2014 1:09 AM by JoMe_264151

    Stopping debugger

    DaHu_285096

       When I halt the debugger (Attached to MiniProg 3), the code continues to run. To get it to stop running, I again run the debugger to start of code and then stop.

         

      Is there a button or something I can click that stops the code in the MiniProg 3 from running?

        • 1. Re: Stopping debugger
          JoMe_264151

          Yes, of course there is a button for "Halt execution", it looks like the "Pause" button on your video-player. In Creator -> Help there is a chapter "Using the Debugger" which explains some more commands thoroughly.

             

           

             

          Bob

          • 2. Re: Stopping debugger
            DaHu_285096

            I have been pressing the STOP button and the code kept running in the Prog3. Pressing Pasue does stop the code and if I press Pause and then Stop, it remains stopped.

               

            This was one of those little things I was meaning to sort out some time. Thanks Bob

            • 3. Re: Stopping debugger
              JoMe_264151

              I am usually quite successful when pressing the "Halt Execution" button, last exit when in a dead loop. Does not work when I use some of the power-reducing states. BTW: The CPU in the target system gets stopped (not in the MiniProg) but the hardware keeps on running.

                 

               

                 

              Bob